FURITEK STEEL U-JOINT DRIVE SHAFT SET FOR FURITEK FX118

A much needed upgrade. I broke the plastic driveshaft while trying to get out of a ditch. Little brushless motor has a lot of torque. I wont have to worry about breaking these steel ones. Fit perfect on my FX-118! If your curious concerning the photo, I 3d printed a battery holder to house two 18650 2500mah batteries. This thing will run for hours without recharging.

D style output shafts on trans side of fx118 fury and input for pumpkin housing have d shaft. Drive lines don't have d style female input. Make it make sense! So sloppy!

Fits perfect, don't forget to phase

Looks great, and does what you expect from a driveshaft. No problems with its ability to turn the wheels and stay together with lots of power from a furitek brushless motor.

Way better fit then factory. Worth buying just for the front drive shaft. Great product easy to unstall

Good stuff!

FURITEK STEEL U-JOINT DRIVE SHAFT SET FOR FURITEK FX118

I broke the plastic stock front driveshaft (tire bound up on an obstacle so to be expected) and was having a hard time finding a replacement so figured I would just go with one straight from the manufacturer. Great fit and initial test indoors just driving around my loft were fine so I took it out to my zero scapped backyard and just driving around on pebble rock the front shaft broke again. The actual union broke not either end that joins at the motor or axel. I’ve reached out Furitek support and after almost 2 week I’ve had no response.

I’m willing to accept it as a one off but they aren’t responding to make it right….

Can't say anything about them as I didn't recieve the product and was refunded my purchase because the wrong address was put on the package and you were unwilling to contact USPS and fix the address. So I will not order from you again. Thank you
Dan Gibbs 7907 Mango Dr Louisville Kentucky 40258

Fast shipping solid product it works But a little on the Expensive side quality is the same as the Amazon parts nothing Different..